Triton JOF 001 Instrucciones De Uso página 5

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Additional Safety for Routers
WARNINGS. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be
sure that the voltage supply is the same as that specified
on the nameplate of the tool. A power source with a
voltage greater than that specified for the tool can result
in serious injury to the user, and damage to the tool. If in
doubt, do not plug in the tool. Using a power source with
a voltage less than the nameplate rating is harmful to the
motor.
• Use safety equipment including safety goggles or
shield, ear protection, dust mask and protective
clothing including safety glove
• Cloths, cord, string etc should never be left around the
work area
• Ensure the mains supply voltage is the same as the tool
rating plate voltage
• Ensure any cable extensions used with this tool are in a
safe electrical condition, and have the correct ampere
rating for the tool
• Completely unwind cable drum extensions to avoid
potential overheating
• Always check walls, floors and ceilings to avoid hidden
power cables and pipes
• Ensure that you have removed embedded objects
such as nails and screws from the workpiece before
commencing operation
• Handle router bits with care, they can be extremely
sharp
• Before use, check the bit carefully for signs of
damage or cracks. Replace damaged or cracked bits
immediately
• Always use both handles and ensure that you have a
firm grip on the router before proceeding with any work
• Before using the tool to make a cut, switch on and let it
run for a while. Vibration could indicate an improperly
installed bit
• Take notice of the direction of rotation of the bit and the
direction of feed
• Keep hands away from the rotating bit
• Never start the router while the cutter is touching the
workpiece
• Ensure the plunge spring is always fitted when using
hand-held
• Ensure the cutter has completely stopped before
plunging to the collet lock position
• Only use router cutters designed for woodwork,
suitable for use between 8,000 and 20,000rpm
• Do not handle cutters immediately after use - they
become very hot
• Only use cutters with a shank diameter exactly
matched to the collet(s) supplied with this router
• Extreme care must be taken when using cutters with a
diameter greater than 2" (50mm). Use very slow feed
rates and/or multiple shallow cuts to avoid overloading
the motor
• Always switch off and wait until the bit has come to a
complete standstill before removing the machine from
the workpiece
• Disconnect from power before carrying out any
adjustment, servicing or maintenance
Safety instructions
5
GB
Tabla de contenido
loading

Productos relacionados para Triton JOF 001

Tabla de contenido