Kenmore 11027542600 Instrucciones Para La Instalación página 8

Connect the inlet hoses to the washer
A. Cold water inlet valve
B. Hot water inlet valve
1. Attach the hot water hose to the bottom inlet valve.
2. Attaching the hot water coupling first makes it easier to
tighten connection with pliers.
3. Screw on coupling by hand until it is seated on the washer.
C
4.
Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
6. Screw on coupling by hand until it is seated on the washer.
7. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Check for leaks
Turn on the water taps and check for leaks. A small amount of
water might enter the washer. You will drain this later.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.
• If you connect only one water hose, you must cap off the
remaining water inlet port.
• Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
1. Remove the shipping material from the power cord. Drape
the power cord over the console.
2. Remove any cardboard used to move washer.
3.
CC>
Beaded tie strap
Wrap the drain hose to the laundry tub leg, drain standpipe or
inlet hoses, with the beaded tie strap. Push fastener into the
nearest hole in the beaded tie strap. See view A or B.
5. Attach the cold water hose to the top inlet valve.
A B C
If the washer taps and the drain standpipe are recessed, put
the formed end of the drain hose into the standpipe. Tightly
wrap the tie strap around the water inlet hoses and the drain
hose. See view C.
8