Tabla de contenido
Idiomas disponibles
Idiomas disponibles
REMOVING THE FREEZER ACCESSORIES
1. Tilting
Pocket
To remove
- Slightly pull the left support
guard ( _
) to the left, allowing the pizza pocket ((_)
just
enough room to slip off the hook. Then pull the pizza pocket
((_)) forward.
Lift up the
bottom
of the support
guard ( 1_ ) and pull it inward to remove it.
To replace
- Hook the ends of the tilting pocket ( 1_ ) onto the support
guards ( _
) and push down
until they are locked into place.
D
2. ice Bucket
To remove
- Open the drawer to full extension.
Then remove the ice bucket ( [_ ) by lifting it up.
(See the illustration
below.)
To relocate
- Place the ice bucket into the drawer ( _
).
am
Super Extended
Drawer
To remove
- Pull the drawer out to full extension.
Tilt up the rear of the drawer and lift straight
out.
To relocate
- Place the drawer onto the rails ( (_)by
tilting it up. Lower the drawer into place until it
is horizontal
and slide the drawer ( _
)in.
4. Freezer Drawer
To remove
the freezer
drawer
- Pull the freezer drawer out fully. Tilt up the rear of the bin and lift it
out to remove.
To relocate
the freezer
drawer
- Place the bin into the rail assembly.
CAUTION
WARNENG
Do not allow babies or children go inside the freezer drawer. They could damage the
refrigerator
and seriously
injure themselves.
Do not sit on the freezer door. The door may
break. Do not allow children to climb into the freezer drawer.
Do not remove the divider.
If trapped
inside, children may become
injury and suffocate
to
CAUTION d eath.
Tabla de contenido
