Personal Precautions; Installation Instructions - Schumacher Electric INSTANT POWER IP-1875C Manual Del Usuario

1.12 This Instant Power™ employs parts, such as switches and circuit breakers, that tend to
produce arcs and sparks. If used in a garage, locate this Instant Power™ 18 inches (46
cm) or more above floor level.
2.

PERSONAL PRECAUTIONS

2.2 Remove personal metal items such as rings, bracelets, necklaces and watches when
working with a lead-acid battery. A lead-acid battery can produce a short-circuit current
high enough to weld a ring or the like to metal, causing a severe burn.
2.3 Be extra cautious, to reduce the risk of dropping a metal tool onto the battery. It might
spark or short-circuit the battery or other electrical part that may cause an explosion.
2.4 Do not permit the internal battery of the Instant Power™ to freeze. Never charge a
frozen battery.
2.5 To prevent sparking, NEVER allow clips to touch together or contact the same piece
of metal.
2.6 Consider having someone nearby to come to your aid when you work near a
lead-acid battery.
2.7 Have plenty of fresh water and soap nearby in case battery acid contacts your skin,
clothing or eyes.
2.8 Wear complete eye and body protection, including safety goggles and protective
clothing. Avoid touching your eyes while working near the battery.
2.9 If battery acid contacts your skin or clothing, immediately wash the area with soap and
water. If acid enters your eye, immediately flood the eye with cold running water for at
least 10 minutes and get medical attention right away.
2.10 If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT
induce vomiting. Seek medical attention immediately.
3. PREPARING TO USE THE INSTANT POWER™
Power™. During cleaning, keep airborne corrosion from coming into contact with your
eyes, nose and mouth. Use baking soda and water to neutralize the battery acid and
help eliminate airborne corrosion. Do not touch your eyes, nose or mouth.
3.3 Determine the voltage of the battery by referring to the vehicle owner's manual and
make sure that the output voltage of the Instant Power™ is correct.
3.4 Make sure that the Instant Power™ cable clips make tight connections.
4. CHARGER AND AC POWER CORD CONNECTIONS
of an adapter plug in the United States is not recommended and should not be used.
5.

INSTALLATION INSTRUCTIONS

Remove all cord wraps and uncoil the cables prior to using the Instant Power™.
RISK OF EXPLOSIVE GASES. A SPARK NEAR
THE BATTERY MAY CAUSE A BATTERY
EXPLOSION. TO REDUCE THE RISK OF A
SPARK NEAR THE BATTERY:
2.1
the vicinity of a battery or engine.
RISK OF ONTACT WITH BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is well ventilated while
the Instant Power™ is being used.
3.2 Clean the battery terminals before using the Instant
RISK OF ELECTRIC SHOCK OR FIRE.
4.1 The Instant Power™ charger is for use on a nominal 120-
volt circuit. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes and
ordinances. The plug pins must fit the receptacle (outlet). Do not
use with an ungrounded system. NOTE: Pursuant to Canadian
Regulations, use of an adapter plug is not allowed in Canada. Use
• 3 •
NEVER smoke or allow a spark or flame in