Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
(5) As shown in Fig 19, 20, insert a turned
portion of set plate (A) attached to set
plate (B) into a groove on the flat portion
of the cutter block.
(6) As shown in Fig 21, place the blade holder
on the completed assembly and fasten it
with the three bolts. Ensure that the bolts
are securely tightened. Follow the same
procedures for the opposite side carbide
blade.
< Resharpenable blade type >
1. Blade disassembly:
(1) As shown in Fig. 15, use the accessory
box wrench to loosen the three bolts
used to retain the blade, and remove the
blade holder.
(2) As shown in Fig. 22, slide the blade in the
direction indicated by the arrow to
disassemble the blade.
CAUTION:
Be careful not to injure your hands.
20
Fig. 19
Groove
Fig. 20
Blade Holder
Bolt
Fig. 21
Fig. 22
Flat Portion of
the Cutter Block
Set Plate (A)
Blade
Tabla de contenido
