Starting Engine; Stopping Engine - MTD 460 Serie Manual Del Operador

Operation
Starting Engine
WARNING: Be sure no one other than the operator
is standing near the lawn mower while starting
engine or operating mower. Never run engine
indoors or in enclosed, poorly ventilated areas.
Engine exhaust contains carbon monoxide, an
odorless and deadly gas. Keep hands, feet, hair and
loose clothing away from any moving parts on
engine and lawn mower.
Follow the set of instructions pertaining to your unit. Refer to
engine manual for help with the engine.
Briggs & Stratt0n Engine:
I. Push the primer three times. Wait about two seconds
between each push. See Fig. 5-I. Do not prime to restart a
warm engine.
2. Standing behind the mower, squeeze the blade control
against upper handle.
3. Holding these two handles together firmly, grasp recoil
starter handle and pull rope out with a rapid, continuous,
full arm stroke. See Fig. 5-I. Keeping a firm grip on the
starter handle, let the rope rewind slowly. Repeat until
engine cranks. Let the rope rewind each time slowly.
l{0hler Engine:
I. Standing behind the mower, squeeze and hold the blade
control against upper handle.
2. Pull the recoil starter lightly until resistance is felt, then pull
rapidly to overcome compression, prevent kickback, and
start the engine. Repeat if necessary. See Fig. 5-2.
NOTE: Do not allow the recoil starter to snap back against
the rope guide.
Stopping Engine
1. Release blade control to stop the engine and blade.
i_ WARNING: Wait for the blade to stop completely
before performing any work on the mower or to
remove the grass catcher.
f
Figure 5-1
Figure 5-2
13