Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Topcom Twintalker 5010
When group scan is enabled, the stand-by channel will always be
included during the group scan.
13.12 Automatic power off (APO)
To save energy, you can activate the automatic power off function. In case you forgot
to power off the unit, it will switch off automatically after the set time.
•
Press the
power off time flashes on the display. (0, 30, 60 or 90
minutes).
•
Use the
the time. Select '0' to disable the APO feature.
•
Press the PTT-button
stand-by mode.
13.13 Key tone on/off
When a button is pressed, the unit will beep briefly.
•
Switch off the PMR (press the
three seconds).
•
Press-and-hold the
the PMR by pressing the
seconds.
•
The key tone will be switched.
13.14 Stopwatch
The Twintalker 5010 has a stopwatch function (mm:ss).
•
Press the
displayed.
•
Press the
•
Press the
see the lap time. The counter continues in the
background. Press the
counting.
•
When the counter is stopped, press the
10
After selecting this function, and also after resetting the counter,
the measurement should be started within 5 seconds. If not, the
device shall return to stand-by.
8
9
-button
four times, the current
5
10
-button
or
-button
12
to confirm and return to
-button
10
-button
while switching on
-button
-button
five times. The counter is
9
5
-button
to start counting.
5
-button
again to stop counting and
5
-button
to reset the counter.
13.15 Roger beep on/off
After the PTT-button
that you have stopped talking.
13.16 Key lock
to change
9
for
9
for three
The Button Lock is not valid for the monitor function, the
button
13.17 Display back light
To activate the backlight of the LCD display, press any button except the PTT-button
12
or the
The LCD backlight will light up for 5 seconds.
14
Earpiece connection
to proceed
The Twintalker 5010 can be used with an optional earpiece.
The connector is located under the protective rubber cover on the top of the unit.
-button
To attach the earpiece, remove the rubber flap to expose the connector.
Insert the earpiece plug into the connector (2,5mm jack)
The small button on the earpiece has the same function as the PTT-button
unit.
When you use the PTT-button
microphone from the earpiece wire.
12
is released, the unit will send out a roger beep to confirm
•
Switch off the PMR (press the
•
Press-and-hold the
the PMR by pressing the
•
The roger beep function will be switched on or off.
•
If the roger beep icon appears in the display, it means
that this function is on.
•
Press the
-button
•
Use the
-button
•
Press the PTT-button
stand-by mode.
•
Press the
-button
the key lock.
9
,
-button
and the PTT-button
11
button
11
12
from the Earpiece, you must also use the
9
-button
)
-button
while switching on
5
-button
9
.
9
eight times.
5
10
or
-button
to select Y.
12
to confirm and return to
9
for four seconds to disable
-
.
12
1
.
12
on the
Topcom Twintalker 5010
Tabla de contenido
