Battery Change; Use - unGer STINGRAY Manual De Usuario

3.4 Battery change

• Two 1,5V AA batteries are required.
• The battery compartment is below the pouch.
• Simply remove the pouch from the compartment during battery change.
• Unscrew the battery lid.
• Remove old batteries and dispose of in accordance with applicable federal,
state/provincial and local regulations and directive.
• Replace with new batteries. Pay attention to the correct orientation of each
battery.
• Close the compartment and secure the lid with the screw.
• Do not expose batteries to direct sunlight, heat or fire.
There is a risk of explosion!

4. Use

Every Easy-Click pole section has its own activation button to start the pump. It's most useful to use the
lowest button that is close to your lower hand. The triangle shape makes it easy to reach in every corner.
1
2. Start by cleaning the window frames. Turn the right edge of
the TriPad to next frame side and move it to the next corner.
Turn again the edge to next frame, move down and repeat that
for all 4 corners of the window (see also picture on page 7).
3. Clean the inner area of the window. You can clean from side to
side or from top to bottom. Always turn the triangle head to the
side beyond.
8
Stingray Cleaning System
Installation / Use
1. Before beginning a new cleaning job or when using a new pad, press
the activation button for four seconds to pre-moisten the TriPad.
Use circular motions to dampen the entire surface of the TriPad.
During the cleaning process use as little liquid as possible. If you need to
re-moisten the TriPad, hold the activation button for about 1 second per
square metre.
You don't need to use much of the Glass Cleaner. Because the TriPad is
made from high performing microfibre material, it only needs to be damp
to achieve the best cleaning results.
www.ungerglobal.com
2.
1.
3.
2
4...
3