Operational Warnings; Optional Remote Control - Elledi RODI STEEL Manual De Uso Y Mantenimiento

Operational warnings

• Switch off the thermo-stove in case of failure or improper operation using the P3 key.
• Do not put pellets manually into the brazier.
• The unburnt pellets built up in the brazier must be removed before switching on the thermo-stove again.
• Do not put fuel other than wood pellets into the fuel tank.
• Do not switch on the thermo-stove using flammable materials in case of falure of the switch-on system.

Optional Remote Control

IR remote control to remotely operate the thermo-stove
1
2
3
4
Synthetic scheme of phases
PHASE
FINAL CLEANING
IGNITING
FLAME WAIT
FLAME PRESENT
WORK
MODULA WORK
ECO STOP
T ON
VENTILA WAIT START
VENTILA WAIT
RESTART
SWITCH ON RESTART
WAIT
HOT SMOKE
WATER STAND-BY
OFF
Switch-on or Flame Wait
PELLETS RUNNING OUT
! IMPORTANT
Model Rodi Steel Use and Maintenance Manual
• 1 - 2 Temperature adjustment:
• 5 - 6 Power adjustment:
• 3 ON/OFF:
6
• 4 With no function
5
DESCRIPTION
The thermo-stove is in the off phase and the cooling phase has not yet been completed
The candela preheating stage has been started, and pellets are beginning to fall into the brazier
Pellets will ignite using the heat of the intake air passing through the incandescent resistor conduit
A flame can be seen in the brazier
The thermo-stove has completed the switch-on phase
The room temperature/ boiler water temperature set point has been reached.
Comfort Climate activated, room temperature set point reached (air), or "Water temp set point +
delta comfort climate" (water). The thermo-stove is off
The room sensor is not working or an external thermostat is connected
The thermo-stove is in the cooling phase: once this condition has been reached, it starts
automatically
The thermo-stove is in the cooling phase: once this condition has been reached, it restarts
automatically
The hot restart phase has been started. Operation is similar to that in the SWITCH-ON phase
The maximum threshold has been reached: for cooling, the thermo-stove reduces the pellet load to
PT 01 and keeps a PT 05 draught
A water temperature of 85°C has been reached. The thermo-stove automatically switches to
STAND-BY mode to ensure hydraulic circuit protection
The thermo-stove is off
When a power-on after ECO-STOP is near an automatic switch-off (from TIMER), the thermo-stove
ensures complete cleaning of the basket before switching to FINAL CLEANING
IF "HOT SMOKE" IS DISPLAYED, THERE ARE COMBUSTION PROBLEMS. PLEASE CONTACT
YOUR LOCAL TECHNICAL SUPPORT CENTRE FOR AN INSPECTION
allows setting the room temperature value desired, from
a maximum of 40°C to a minimum of 6°C.
allows setting the work power value from a minimum
value of 1 to a maximum value of 5.
if pressed for two seconds, the stove can be manually
switched on and off .
Rev.2 31/07/2017
Page72