Fitting The Harness - Stihl FSB-KM Manual De Instrucciones

Screw the mowing head (1)
N
clockwise on to the shaft (2) as far
as it will go
Block the shaft, see "Blocking the
N
shaft"
Tighten down the mowing head (1)
N
firmly
NOTICE
Remove the tool that was used to block
the shaft.
Removing the Mowing Head
Block the shaft, see "Blocking the
N
shaft"
Turn the mowing head
N
counterclockwise
FSB-KM

Fitting the Harness

The type and style of the harness,
1
carrying ring and carabiner (spring hook)
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
2
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder strap
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attaching Machine to Harness
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube –
hold the carrying ring steady.
Detaching Machine from Harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing Off the Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
power tool as you would in an
emergency. To avoid damage, do not
throw the power tool to the ground when
practicing.
English
2
1
1
2
1
1
2
2
15