Cembre B1350-UC Manual De Uso página 9

2.1) Preparation
When introducing or changing dies, the battery
must first be removed from the tool.
The tool can be easily carried using either the handle or the
shoulder strap attached to ring (10) (Ref. to Fig. 1).
Before starting any work, check the battery charge
(Ref. to § 2.8) and recharge if necessary, following the
instructions in the battery charger user manual.
To replace the battery, remove it by pressing the release
button (7), then insert the new battery, sliding it into the
guides until it locks.
The display shows the operational parameters of the tool;
to customise them proceed as described in § 2.7.
Depending on the compression to be performed, proceed as described in § 4 or 5.
2.2) Die advancement
Press operating button (4) to activate the motor-pump and advance the lower die.
To halt the advancement, release operating button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise re-open dies
following instructions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (4) pressed, the motor con-
tinues to operate: the ram will gradually move forward
until the two dies touch.
The motor will stop automatically when the set pressure
has been reached.
To perform proper compression, press and hold the
operating button (4) until the motor stops automati-
cally.
9
Battery
4
7