Connecting Audio Components Via An Analogue Cable - Silvercrest KH6779 Instrucciones De Uso

Connection via coaxial cable
To connect the DVD player to a digital audio component with a digital coaxial
cable:
COAXIAL
• Connect the inscribed plug to the corresponding socket on the
digital audio component.
Connecting via optical cable
To connect the DVD player to a digital audio component with an optical cable:
• Remove the protective plug from the
panel of the DVD player and insert the optical cable plug.
• Insert the plug at the other end of the optical cable in the corresponding
socket of the digital audio component.
Note:
The optical cable is a glass fibre cable and must not be bent during
installation. Otherwise the glass fibre contained in the cable could
break and the cable would become unusable.
Note:
Make sure that no dirt can enter into the optical cable socket. This could
cause signal interference. Always insert the protective plug into the socket
if no optical cable is connected.
OPTICAL
inscribed socket on the rear

9.3 Connecting audio components via an analogue cable

If a digital input is not available on the audio component you can connect
the DVD player to it via conventional analogue cinch cables.
To connect the DVD player with analogue cables:
• Plug a cinch cable into each of the sockets
SL
right channel), (rear left channel),
SUBWOOFER
centre channel) and
• Insert the cinch cables into the corresponding analogue inputs of the
audio component.
- 55 -
FL FR
(front left channel),
SR CENTER
(rear right channel),
(Bass) on the rear panel of the DVD player.
(front
(front