Velleman DVM8855 Manual Del Usuario página 4

• 1mv/°F (1.8mV/°C) analogue output
• adjustable emissivity
• high and low alarm
• contents: manual, tripod, K-type thermocouple, wireless USB receiver, wireless USB transmitter,
software, power supply, connection lead for mV output, carrying case
5. Overview
Refer to the drawings on page 2 of this manual.
1 IR sensor
2 laser pointer beam
3 LCD display
4 down button
5 up button
display
A scan indication
B hold indication
C auto emissivity
D emissivity indication and value
E lock and laser ON indication
inside battery compartment
L °C and °F switch
6. Operation
• Hold the thermometer by the grip [9] and point the IR sensor [1] towards the surface of which the
temperature needs to be measured.
• Pull and hold the measurement trigger [8]. The LCD display [3] shows the current temperature
[K].
• During measurement, the word 'SCAN' [A] is visible in the LED display. When the measurement
stops (trigger [8] released), the word 'HOLD' [B] is shown. The last measured value will remain on
the display until the measurement trigger [8] is pulled again, or when the thermometer powers-off
automatically (after ± 7 seconds).
• Depending on the mode, the bottom of the screen shows the MAX, MIN, DIF, AVH, HAL, LAL Tk or
memory values. Use the mode button [6] to scroll through the modes of the device. The mode [J]
and corresponding value [H] are shown on the display.
EMS
MAX
MIN
DIF
AVG
HAL
LAL
Tk
LOG #
• To set EMS, HAL or LAL, use the up [5] or down [4] button to adjust the value and press the mode
button [6] again to save the value and go to the next item. To cancel mode selection, pull the
measurement trigger [8]. Pushing the mode button [6] after setting the lower alarm limit will start
the set-up cycle again.
• Note that MAX, MIN, DIF and AVG only apply to the current measuring session (time between pulling
the trigger [8] and releasing it). Their value is reset when a new measurement starts or the
thermometer switches off.
• To switch between measurements in °C and °F, open the battery cover [10]. The battery cover has
a hinge at the bottom of the device. Hold the battery cover at the top (next to the measurement
trigger [8]) and gently pull away from the device.
02/03/2009
F °C or °F indication
G low battery indication
H MAX, MIN, DIF, AVG, HAL, LAL, Tk and memory values
I high and low alarm indication
J indication for H
K current measurement value
(*)
Emissivity
Highest measured value
Lowest measured value
Difference between the highest and lowest measured value
Average value of the temperature
Higher alarm limit
Lower alarm limit
Temperature measured via thermocouple
Show memory location number # (max. 20) value
(*)
For more information on emissivity, refer to §8 Useful information.
DVM8855
6 mode button
7 laser/backlight button
8 measurement trigger
9 grip
10 battery cover
M lock on/off switch
N alarm set switch
4
© 2008 Velleman Components nv