Shop-Vac 92 Serie Manual De Usuario página 8

4. Slide remaining wheel then washer onto axle. Insert hair pin clip into remaining
hole in axle to hold wheel in place.
5. With front of tank facing you, take basket assembly and place into slots on back of
tank. Secure with screws provided.
6. Take caster foot marked with the letter A and place in slot on left front of tank
also marked with letter A. Secure with screw provided.
7. Take caster foot marked with the letter B and place in slot on right front of
tank also marked with the letter B. Secure with screw provided.
8. If flat washers are included in hardware package place flat washer over
stem of caster before installing casters into feet. NOTE: Flat washers are not
required with all units.
9. Insert casters into feet by placing stem of caster into holes provided.
Apply pressure and twisting motion until casters snap into place. Return
tank to upright position.
CARRIAGE HANDLE
If your vacuum comes with a carriage handle, assemble as follows:
1. Stand tank in the upright position. Spread ends of carriage
handle (to prevent damage to tank) while placing them
under the side tank handles.
2. Align holes in carriage handle with holes in tank. Fasten
tightly with screws, washers and nuts provided. The rubber
side of the washers must be placed against the inside wall
of the tank to prevent leakage or loss of performance.
TOOL HOLDER
(Not standard with all models)
If your unit came with a tool holder, assemble as follows:
1. Set tank cover onto the tank. Position with back of tank cover facing you.
2. Press tabs of tool holder into the slots on mounting
lugs, located on back of tank cover.
PAGE 8
ASSEMBLY (CONT'D.)
Screw
Caster
Foot
Screw
Caster
Foot
Caster
Caster
Foot
Carriage Handle
Sealing Washer
Hex Head Locknut
Screw