EMKO EZM Serie Manual De Instrucciones página 8

Parameter Definitions
:Input Type and Functions (Default=3)
0 : Upcount on rising edge of Ch-A input.
1 : Down count on rising edge of Ch-A input.
2 : Upcount on rising edge of Ch-A input
edge of Ch-A input
3 : Upcount on rising edge of Ch-A input,Upcount on rising edge of
Ch-B input . (INC/INC)
4 : Upcount on rising edge of Ch-A input when Ch-B is at 0
edge of Ch-A when Ch-B is at 1.
5 : x1 Phase Shifting
6 : x2 Phase Shifting
7 : x4 Phase Shifting
: Filter time for Ch-A and Ch-B Inputs
It is used to protect against the electrical contact debounce or the signal that is less
than the determined pulse time.
It can be adjusted from
: Filter time for Reset and Pause Inputs
It is used to protect against the electrical contact debounce or the signal that is less
than the determined pulse time.
It can be adjusted from
:Count Direction (Default=0)
Upcount. ( 0 -->Preset )
Downcount. ( Preset--> 0 )
:Sensor Type Selection (Default=0)
NPN Sensor type is selected.
PNP Sensor type is selected.
:Output Functions (Default=0)
0:
Manuel Reset-1: Process
counts,until manuel reset
happens.When count
value reaches the Set
value,Output Position is
changed.
(INC)
, Down
.(INC/DEC)
(UP/DOWN)
.(for Incremental Encoder)
.(for Incremental Encoder )
.(for Incremental Encoder )
to
to
(DEC)
count on rising
Down count on rising
(Default=0)
milisecond.
(Default=50)
milisecond.
8