Typical Tig Connections - Miller Syncrowave 200 Manual Del Propietário Y Guía

2-13. Typical TIG Connections

2
1
Tools Needed:
5/8, 1-1/8 in.
6
7
3
!
Turn off power before mak-
ing connections.
1 Remote Foot Control
A customer supplied remote finger-
tip control may also be used.
2 Torch
3 Work Clamp
5
Connect remote control, torch, and
work clamp to receptacles as
shown.
4 Cylinder
Chain or secure cylinder to running
gear, wall, or other stationary
support.
5 Cylinder Valve
Open valve slightly so gas flow
blows dirt from valve. Close valve.
6 Regulator/Flow Gauge
Install so face is vertical.
7 Flow Adjust
4
Typical flow rate is 20 cfh (cubic feet
per hour) (9.4 L/min).
After activating remote control, 0.2
seconds of gas preflow will begin.
Preflow Application:
Preflow is used to purge the imme-
diate weld area of atmosphere.
Preflow also aids in consistent arc
starting. Preflow is preset and is not
adjustable.
Post Flow Application:
Postflow is required to cool tung-
sten and weld, and to prevent con-
tamination of tungsten and weld. In-
crease postflow time if tungsten or
weld are dark in appearance (see
Section 3-8).
OM-225 389 Page 11