Idiomas disponibles
Idiomas disponibles
7
ADJUST LANDING PAD POSITIONS THEN TIGHTEN THEM DOWN.
Using your tower
instructions as a
reference, carefully
place an assembled
crossbar with towers
onto the Landing Pads.
Align position of
Landing Pads to allow
SkyLine or Control
Towers to fully close.
Center crossbars
and fully torque
your SkyLine or
Control towers to the
crossbars according to
the tower instructions.
NOTE: Due to manufacturing variations the fastening hardware may bottom out in the hardpoint before the Landing Pad is fully
tight. If you encounter this situation, go back to step 6 and re-install with additional metal washer(s) (up to 3) to take up the slack.
8
READ THESE WARNINGS!
Make sure SkyLine
or Control Towers,
with bars installed,
seat completely with
Landing Pad. If they
do not seat properly,
clean Landing Pads and mounting points periodically
repeat step 7.
9
CONTINUE WITH SKYLINE OR CONTROL TOWER INSTALLATION.
INSTRUCTION #1033512N - PAGE 4 of 36
Be sure all hardware is secured according to
instructions. Failure to perform safety checks
before driving away can result in property damage,
personal injury, or death.
Attachment hardware can loosen over time. Check
and tighten if necessary, before each use.
To avoid damage to your vehicle's finish remove and
as road sediment will accumulate over time.
Open one SkyLine or Control
Tower cover and lift it up while
opposite tower is still engaged.
While holding SkyLine or Control
Tower above Landing Pad, fully
tighten Landing Pad with long
handle as shown. If your vehicle
requires spacers torque to 27
in-lbs (3 Nm). DO NOT OVER
TIGHTEN AS DAMAGE TO
ROOF MOUNTING POINTS MAY
OCCUR.
Repeat the process again for the
other Landing Pads to ensure
they have not changed position.
Re-insert SkyLine or Control
Tower into the Landing Pad, fully
tighten the tower (refer to tower
instructions) and close the cover.
DO NOT EXCEED MAXIMUM
WEIGHT LIMIT FOR YOUR VEHICLE.
To review your vehicle's specific
weight limit and load limitations for
accessories, visit yakimatech.com.
For additional product support ,
visit yakima.com/support or contact us
Monday through Friday, 7:00 AM
Remove your YAKIMA rack and accessories
before entering automatic car washes.
27 in-lbs (3 Nm)
directly at (888)925-4621
to 5:00 PM, PST.
