Idiomas disponibles
Idiomas disponibles
6
ATTACH LANDING PADS.
Refer to the fit chart
on page 5 (or online at
yakimatech.com if your
vehicle is not listed) to
determine the correct
hardware for your vehicle.
A.
Put Landing Pad in place on a clean and dry rooftop.
B.
Stack metal washer on top of plastic washer with convex side of plastic
washer facing down. Add washers as needed to prevent bolt from
bottoming out.
C.
Put fastener through washers, through Landing Pad, and thread into
threaded mounting point in rooftop.
D.
Thread the fastener, and tighten with short handle as shown, but do
not fully tighten. USE CAUTION NOT TO CROSS THREAD FASTENER.
E.
Jostle and rotate Landing Pad in all directions to ensure plastic washer
is fully seated, also allowing Landing Pad a small amount of play to
prepare for final alignment and tightening in step 7.
F.
Repeat for second Landing Pad.
A
INSTRUCTION #1033512N - PAGE 3 of 36
Use M6 spacer if
M6
required for your vehicle.
Hardware
B
Convex
side
down.
BE SURE TO USE THE CORRECT
LENGTH OF HARDWARE!
M8
M6 X 50 M6 X 40
Hardware
WARNING: DO NOT ALLOW
EDGES OF PAD TO CURL UNDER!
C
D
NOTE: Final tightening will happen in the next step.
M6 X 30
M8 X 45 M8 X 40
E
