HIKOKI WR 18DJL Instrucciones De Manejo página 6

English
● Regarding the temperatures and charging time of the battery.
The temperatures and charging time will become as shown in Table 2-a, 2-b.
Type of battery
Temperatures at which the
battery can be recharged
Charging voltage
Battery
Charging time,
approx. (At 20°C)
Type of battery
Temperatures at which the
battery can be recharged
Charging voltage
Battery
Charging time,
approx. (At 20°C)
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
CAUTION
When the battery charger has been continuously used,
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
4. Disconnect the charger's power cord from the
receptacle.
5. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
CAUTION
○ If the battery is charged while it is heated because it has
been left for a long time in a location subject to direct
sunlight or because the battery has just been used, the
pilot lamp of the charger lights for 1 second, does not
light for 0.5 seconds (off for 0.5 seconds). In such a case,
fi rst let the battery cool, then start charging.
○ When the pilot lamp fl ickers in red (at 0.2-seconds
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery or charger is
malfunctioning. Take it to your authorized Service Center.
Charger
V
(5 cells)
BSL1815S : 20
BSL1815 : 22
BSL1815X : 22
min.
BSL1820 : 30
BSL1825 : 35
BSL1830C : 45
Charger
V
(5 cells)
BSL1815S : 35
BSL1815 : 40
BSL1815X : 40
min.
BSL1820 : 60
BSL1825 : 75
BSL1830C : 90
Table 2-a
UC18YFSL
Li-ion
0°C – 50°C
18
BSL18xx series
(10 cells)
BSL1830 : 45
BSL1840 : 60
BSL1850 : 75
BSL1860 : 90
Table 2-b
UC18YKSL
Li-ion
0°C – 50°C
18
BSL18xx series
(10 cells)
BSL1830 : 90
BSL1840 : 120
BSL1850 : 150
BSL1860 : 180
○ Since the built-in micro computer takes about 3
seconds to confi rm that the battery being charged with
charger is taken out, wait for a minimum of 3 seconds
before reinserting it to continue charging. If the battery
is reinserted within 3 seconds, the battery may not be
properly charged.
MOUNTING AND OPERATION
Action
Removing and inserting the battery
Charging
Mounting the socket
Reversing the rotational direction
Switch operation
How to use the LED light
Selecting accessories
6
Multi volt series
(10 cells)
BSL36A18 : 75
BSL36B18 : 120
Multi volt series
(10 cells)
BSL36A18 : 150
BSL36B18 : 240
Figure Page
1 149
2 149
3 149
4 149
5 149
6 149
― 151