Spectrum Analyser Mode Configuration - Promax 10 premium Guía De Usuario

The lower line (TIME) shows the time since the detector is active.
The COUNTER field shows the number of impulses that have exceeded the
level defined by the REF. LINE parameter in the configuration menu of the SPECT
mode (section 4.2.5.5).
To initialise the TIME and COUNTER fields, press the SPECT [13] key.
In the lower part of the screen it appears a bar that shows present level, a
dotted line shows the detection threshold (REF. LINE) whereas the continuous line
indicates the maximum detected level.
4.2.4.5

SPECTRUM ANALYSER mode configuration

Pressing the CONFIG key [14] will
access the parameter configuration menu
for the SPECTRUM function.
To change the value assigned to one
parameter, turn the rotary selector [9] until its field is
activated (this will appear shadowed) and then
press. The value of the parameter will be
activated and may be changed by turning the rotary selector. When the value you want
appears, press the rotary selector [9] to validate it.
The parameters that can be modified through this menu are:
a) BAND
It selects the analyzed band between:
RETURN PATH Sub-band spectrum (5 to 100 MHz).
FORWARD
b) MODE
It selects the representation mode:
SPECT
MIN
MAX
TRANS
c) DETECTOR (Only for the SPECT, MAX and MIN modes)
It selects the used detector between:
PEAK
AVERAGE
In the TRANS mode the detector used is always PEAK.
Page 38
USER'S MANUAL. PROMAX-10
Figure 46.- SPECT mode configuration.
Band from 45 to 863 MHz.
Instantaneous value.
Minimum values held (MIN INGRESS).
Maximum values held (MAX INGRESS).
Transient detector. Only operative in the return path.
Premium
11/2008