Datalogger Configuration - Promax 10 premium Guía De Usuario

USER'S MANUAL. PROMAX-10
4.2.6.1

Datalogger configuration.

From the LOGGER mode, when
pressing the CONFIG key [14] we will access
to the configuration menu. This menu permits
to modify the THRESHOLD
parameters. To access to them turn the rotary selector
and once the parameter we want to change is
appears shadowed, press it; then turning it its
value will be modified. Finally press it again to
validate the new value.
a) THRESHOLD: It activates / deactivates the measurement threshold.
This parameter allows to carry out the logger function in an agile way, by
activating only those measures we consider significative.
In the OFF mode (deactivated) all measurements are taken (with a level
higher than 20 dBµV). On the other hand, when a level is defined, only
those channels with a level higher than the THRESHOLD value will be
measured.
b) MEASURES: It defines the types of measurements to be made.
This parameter allows to select the measurements that are desired to made
between:
ANALOGUE CHANNELS
Level
LEVEL / POWER Yes
AV - C/N / MER Yes
AV-CN / MER-
Yes
BER
(*) Note: The BER measurements represent an increase of the data acquisition time.
To leave the configuration menu of the DATALOGGER mode, just press the key of
the operating mode you wish to access.
11/2008
Premium
and MEASURES
Figure 53.- Logger configuration menu.
Audio / Carrier /
Video Noise
Ratio Ratio
- -
Yes Yes
Yes Yes
DIGITAL CHANNELS
Power MER BER
Yes - -
Yes Yes -
(*)
Yes Yes Yes
IMPORTANT
Page 43