Clamping The Extensions - Look 796 Monoblade RS Manual De Uso

There are two types of extension fixings: the «extension supports» (Fig. 23.1) and the «BRIDGE»
(Fig. 23.2).
1- Degrease and clean the expanding part of the clamps in contact with the inside of the
extensions to improve their grip. (Fig. 23.1)
2- Push the extensions in until they stop and orient them in the desired position
3- Tighten the clamp screw with 4mm Allen key to 7 Nm torque.
4- It can be necessary to retighten to the 7 Nm torque after some time has elapsed.
GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
CLEAN
Fig. 23.1
GREASE
Note : Grease the contact surfaces between the brass screw and the expander part (bold
lines on the cross-section below)
Nature de la modification
ECHELLE 1:1
Volume (mm3) Masse (g)
19216.07 42.97 FORMAT A4
Dessiné par Date
P.BIGARD 17/03/2016
Vérifié par Date
All information contained on this drawing is property of LOOK CYCLE INTERNATIONAL. Its reproduction for any use in any way or for commercial
purpose is forbidden. All rights on this material are reserved.
B-B

Clamping the extensions

GENERAL TOLERANCES :
Dimension from 0 to 15 : ±0.15
Dimension from 15 to 30 : ±0.20
Beyond : ±0.25
Angles : ±30'
Surfaces finish : 80 grit sand blast
Free of positive metal, voids and porosity
Free of cutting oil and oil residue
B
CLEAN
B
Resp
Matière
GREASE
ENSEMBLE REFERENCE PROTO.
ACT-001
DESIGNATION
Support prolongateur
000 13763
Fig. 24
Nature de la modification
Fig. 23.2
Date Ind.
Traitement
REFERENCE
Matière
EN
B
B
Resp Date Ind.
Traitement
30