Important; Origin Point - KNK Force SCAL Manual De Usuario

Select WYSIWYG or
Origin Point here
•
IMPORTANT: Both Cut Modes are based on setting an XY origin on the cutter. On a Force, this origin is
set by moving the tip of the blade (or pen or tool), on the left side of the dual head, to the lower right corner
of the mat grid or the material.
•
The following sections show where shapes will cut based on the possible combinations of Cut Mode and
Orientation. Note that with WYSIWYG mode, there will be two options and the one that makes the most
sense to you, is the one to use:

Cutting Mat Method: The virtual Cutting Mat is the same dimensions as the actual cutting mat:

Material Method: Create a custom virtual Cutting Mat that matches the dimension of the material to be
cut:
•
The best way to learn how these setting affect where shapes cut is to recreate what you see in these screen
shots and test them out with the test pen and paper. Eventually, it will all make sense to you and, of course,
there's help available if you need it.

10.07.2 Origin Point

•
This is the mode recommended for most applications as it economizes the use of your cutting materials.
Cutting Mat matches
actual mat
Cutting Mat matches
material on mat
240