Ontrolling Where Shapes Will Cut; Overview - KNK Force SCAL Manual De Usuario

10.07 Controlling Where Shapes Will Cut

10.07.1 Overview

•
There are two Orientations for cutting:

Portrait – Shapes will cut in the same orientation you see on the Cutting Mat

Landscape – Shapes will cut 90
•
There are 3 available Cut Modes when cutting to the KNK Force:

WYSIWYG – Shapes will cut relative to their position on the virtual Cutting Mat

Origin Point – Shapes will cut to align with the origin set before cutting

Print and Cut – Shapes will cut based on aligning the camera with printed registration marks (refer to
Chapter 11)
•
The Orientation is set on the Document Panel:
Select either Vertical
(Portait) or Horizontal
(Landscape)
Portrait
•
The choice between Portrait and Landscape is a personal one – use whichever one makes the most sense
to you. For long projects, such as for large vinyl cuts, Landscape is usually chosen because the project
displays better on the computer monitor. However, you still have the option to use Portrait, if desired.
•
The Cut Mode is set in the Cut Settings window:
o
clockwise to the orientation you see on the Cutting Mat
into the
Portrait
Landscape
Landscape
239