Tabla de contenido
To delete any of the lines, click on the Delete icon
window.
Overlap Columns and Overlap Rows: If you want an overlap created so that each tile slightly overlaps
with an adjacent one, check the box and then enter the desired overlap:
Check Overlap
Columns and/or
Overlap Rows and
enter the desired
overlap size
•
After clicking on OK, you won't observe any changes on the Cutting Mat or on the Layers Panel. The
results of the Tiling process will apply once you enter the cutting window. Refer to Section 10.06.3.
10.06 Cut Settings
The cut settings vary from one cutter to the next based on the manufacturer of that cutter and the built-in
functionality. For this reason, the information presented here will only apply to the brand and model of cutter
presented in Chapters 1 and 2.
10.06.1 Cut Window Settings
•
When you are ready to execute a cut (or draw), the cut window can be opened using either of the following:
Click on the Cutter icon
Go to Cutter>Cut With KNK Force
•
The following window will open:
on the Toolbar
and then click on the line inside the Preview
Purple lines
indicate an
overlap is applied
226
Tabla de contenido
