Makita GA7031 Manual De Instrucciones página 8

Installing or removing depressed
center grinding wheel/Multi-disc
(accessory)
WARNING:
• Always use supplied guard when depressed
center grinding wheel/Multi-disc is on tool.
Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
2
3
► 1. Lock nut 2. Depressed center grinding wheel/
Multi-disc 3. Inner flange
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut with its
protrusion facing downward (facing toward the wheel).
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
2
► 1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
NOTE:
• In countries other than United States and
Canada, Inner flange 45 can be also used.
1
Installing or removing flex wheel
(optional accessory)
WARNING:
• Always use supplied guard when flex wheel is
on tool. Wheel can shatter during use and guard
helps to reduce chances of personal injury.
► 1. Lock nut 2. Flex wheel 3. Plastic pad 4. Inner
flange
Follow instructions for depressed center grinding wheel/
Multi-disc but also use plastic pad over wheel. See
order of assembly on accessories page in this manual.
NOTE:
• In countries other than United States and
Canada, Inner flange 45 can be also used.
Installing or removing abrasive disc
(optional accessory)
NOTE:
• Use sander accessories specified in this man-
ual. These must be purchased separately.
► 1. Lock nut 2. Abrasive disc 3. Rubber pad
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
8 ENGLISH
1
2
3
4
1
2
3