Dealing With Paper Jams - Tanita TBF-300A Manual De Instrucciones

11. Dealing with Paper Jams

a Names of Printer Unit Parts
Auto-cutter Unit
Paper Release Lever
* The above diagram shows the Control Box without the Printer Dispenser Cover and the Printer Cover, overhead view.
34
Paper Outlet
CAUTION
When handling the printer unit, please avoid any sharp edges.
Please follow these instructions to clear any paper jams from the printer assembly:
1. Remove the Paper Dispenser Cover by lifting up from the
2. Remove the Printer Cover as displayed. Apply light pressure
3. Raise the Auto-cutter Unit as displayed. Using the pointer
4. Lift the small black lever located on the left side of the
Paper
Release
Lever
5. Be sure to return the Paper Release Lever to its proper
6. Replace the Printer Cover by gently pressing in on the side
7. After completing steps 1 to 5, printer paper can be
back side.
with one finger to the printer cover and lift up as displayed.
finger, gently lift one end of the Auto-cutter Unit, it will
remain upright until returned to the normal horizontal
position.
•Do not attempt to remove the Auto-cutter Unit.
Auto-cutter Unit. This will facilitate the clearing of any
paper jams that may have occurred. The roll of printer
paper must be removed at this time.
Carefully search for and clear any scraps of paper from the
printer assembly, as this may cause jamming in the future.
position. Next, carefully move the Auto-cutter Unit to its
proper position.
IMPORTANT NOTE: Failure to return the Paper Release
Lever to its proper position will result in continuous feeding
of the printer paper. If this occurs, turn off the unit by
pressing the [ON/OFF] key, and follow steps 1 to 5 above.
tabs of the cover as it slides into position.
reloaded. See Loading Printer Paper on P.16 for details.
Replace the Paper Dispenser Cover.
35