Kenmore 110.81422 Manual De Uso Y Cuidado, Instrucciones De Instalación página 32

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Washer not performing as expected (cont.)
Washer won't run
or fill, washer stops
working (cont.)
Washer not draining/
spinning, loads are
still wet
32
TROUBLESHOOTING — WASHER (cont.)
Possible Causes
Check proper electrical supply.
Normal washer operation.
Washer not loaded as
recommended.
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Used a cycle with a low spin speed.
Washer not loaded as recommended.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 4.5" (114 mm).
Too much detergent causing suds
to slow or stop draining and spinning.
Plug into a grounded outlet or reconnect power.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer spins the dry load for several minutes before filling to
determine if load is balanced. You may hear the hum of the spins.
This is normal.
Remove several items, rearrange load evenly in basket and add
detergent. Close lid and pull Cycle knob to start washer.
Do not add more than 1 or 2 additional items after cycle has
started to avoid tightly packing or unbalancing.
Empty pockets and use garment bags for small items.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/spin speed for
your garment. To remove extra water in the load, select Spin. Load
may need to be rearranged to allow even distribution of the load
in the basket.
Tightly packing or unbalanced loads will not allow the washer to
spin correctly, leaving the load wetter than normal. See "Washer
Use" for loading recommendations.
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening. Lower drain hose if the end is higher than 96" (2.4 m)
above the floor. Remove any clogs from drain hose.
Always measure and follow detergent directions for your load.
To remove extra suds, select Rinse and Spin. Do not add
detergent.
Solution