Puky CAT Manual De Instrucciones página 9

Assembly
For assembly instructions, refer to the last
pages of this manual.
For assembly, you will need the following tools
(Figure B):
1. Open end wrench, 10 mm
2. Allen wrench, 5 mm
3. Screw driver (slotted)
Small­parts­required­during­assembly­(for­
example­screws­and­washers)­should­be­
kept­out­of­reach­of­small­children.­There­is­
a­risk­of­suffocation­if­swallowed.­
Assembly must be done carefully by an adult
to prevent accidents or injuries later on. Make
sure to take enough time for this. Some as-
sembly work requires manual dexterity and
familiarity with tools (i.e. wrenches.) If you are
not sure, please refer to your specialized deal-
er or a workshop.
In some places, screws need to be tightened
with a specific torque. This torque is given in
newton meters (i.e. 2 Nm.) If a screw is tight-
ened with insufficient torque, the connection
may be too loose and unsafe. If the torque is
too great, screws and other parts can be dam-
aged or destroyed.
User Manual
Figure 1: Remove screws and insert rear axle
into frame
Align­square­nuts­facing­backwards.
Figure 2: Put screws in place and tighten.
Figure 3: Remove transport restraint (rubber
band) and take off the washer.
Figure 4: Push fork shaft through the steering
head tube until the stop. Put the washer back
on.
Align the nibs on the fork shaft to face
backwards.
Figure 5: Push the handlebars onto the fork
shaft until the stop and tighten screw. Next,
push the spherical cap down until it snaps into
place.
Align the slot on the steering shaft to face
backwards.
Figure 6: Remove both screws from the seat
holder
Figure 7: Put on the seat and fasten it with
screws.
Figure 8: Assemble push bar tube, grip and
shovel (only CAT 1SP.)
Figure 9: Insert push bar into the seat holder
and lock in.
Make sure that the catch (spring) snaps in
correctly.
Figure 10: Push trough onto rear axle until it
snaps into place.
Figure 11: (only CAT 1SP) Affix netting on
trough and use it to fasten the mesh insert.
9
GB