Maintenance Chart - Bostitch BTFP02006 Manual De Instrucciones

easier.
note: Any service operations not included in this section should be performed by Bostitch
authorized service center.

MAINTENANCE CHART

procedure
Check safety valve (G)
Inspect air filter +
Drain air tank (H)
Check pump oil level (J)
Change pump oil** +
Oil leak inspection
Check for unusual noise/
vibration
Check for air leaks
Clean compressor exterior
Remove tank from service
1 - To check for air leaks apply a solution of soapy water around joints. While compres-
sor is pumping to pressure and after pressure cuts out, look for air bubbles to form.
2 - Remove tank from service. For more information, call our Customer Care Center
1-800-556-6696
at
** The pump oil must be changed after the first 20 hours of operation. Thereafter,
ISO 100/SAE40, non­detergent, premium air compressor oil
when using
change oil every 200 hours of operation or once a year, whichever comes first.
+ Perform more frequent in dusty or humid conditions
CHECkING SAFETY VAlVE (FIG. 1)
Hot surfaces. Risk of burn. Aftercooler, pump head, and surrounding parts are
very hot, do not touch (see the Hot Surfaces identified in Fig. 2). Allow compressor to cool
prior to servicing.
Risk of bursting. If the safety valve does not work properly, over-pressurization
may occur, causing air tank rupture or an explosion.
Risk from flying objects. Always wear certified safety equipment :
ANSI Z87.1 eye protection (CAN/CSA Z94.3) with side shields when using the compressor.
Before starting compressor, pull the ring on the safety valve to make sure that the safety valve
operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the
same type of valve.
CHECkING AIR FIlTER ElEMENT (FIG. 1)
Hot surfaces. Risk of burn. Aftercooler, pump head, and surrounding parts are
very hot, do not touch (see the Hot Surfaces identified in Fig. 2). Allow compressor to cool
prior to servicing.
1. Ensure the On/Off switch (A) is in the OFF position.
2. Allow unit to cool.
3. Remove air filter (L) from unit.
4. If element needs cleaning, blow out with air. Replace if needed. Purchase replacement
parts from your local dealer or authorized service center. Always use identical
replacement parts.
Daily Weekly Monthly
X
X
X
X
X
X
X 1
X
15
1 year see tank
or 200
warning label
hours
X
X²
,