Maintenance; Clean The Machine; Store The Machine; Troubleshooting - Powerworks P2448C Manual Del Operario

2. Use 2 wood screws to attach the charger on the
wood studs.
3. Drill two paralleled holes 5" (127 mm) on center.
4. Use wall anchors and screws to attach the charger
to the drywall.
NOTE
If you do not use the battery pack and charger for a
long time, please remove the battery from the charger
and pull out the AC power plug.
6

MAINTENANCE

6.1

CLEAN THE MACHINE

NOTE
Keep the air vent free of blockage, saw dust, and
wood dust. Do not spray, wash, or put the air flow in
water.
• Clear the unwanted material out of the air vent with
a vacuum.
• Clean housing and the plastic components with a
dry and soft cloth.
IMPORTANT
Do not use strong solvents or detergents on the plastic
housing or components.
6.2

STORE THE MACHINE

• Remove the battery pack before you store the
charger or disconnect the charger.
English
7

TROUBLESHOOTING

PROBLEM
Charger doesn't
work. Charger
shows defective
mode. (LED fla-
shes Red)
Charger doesn't
work. Charger
shows evaluati-
on mode (LED
indicates Red
solid ON).
8

TECHNICAL DATA

Model
Voltage
Input
Output
Model
Voltage
Input
Output
9

WARRANTY

(The full warranty terms and conditions can be found on
webpage)
The warranty is 3 years on the product, and 2 years on
batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A
faulty product under warranty might be either repaired
or replaced. A unit that has been misused or used in
other ways then described in the owner's manual might
be rejected for warranty. Normal wear, and wear parts
are not considered as warranty. The original
21
POSSIBLE SOLUTION
CAUSE
Try to remove
and reinsert the
battery pack in
the charger.
Battery pack or
Try charging a
charger is defec-
different battery
tive or there is a
pack.
bad connection
between the bat-
Unplug the char-
tery pack and
ger and wait until
charger.
the red LED
goes out, then
reconnect the
plug to the power
supply.
Allow the battery
pack to reach
normal tempera-
Battery pack is ture. Charging
either too hot, or will begin when
too cold. the battery pack
returns to
3°C-47°C
(37°F-117°F).
P2448C
24 - 48 V
230 V AC 50-60 Hz 2 A
4V DC 2A
P2448C4
24 - 48 V
230 V AC 50-60 Hz 2,5 A
24V DC 4A
EN