Operation; Charge Procedure; Examine The Charger; Mount The Charger - Powerworks P2448C Manual Del Operario

If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Dispose of
the battery and replace with a new battery pack. DO
NOT ATTEMPT TO REPAIR IT! To avoid injury and
risk of fire, explosion, or electric shock, and to avoid
damage to the environment:
• Cover the battery's terminals with heavy-duty
EN
adhesive tape.
• DO NOT attempt to remove or destroy any of the
battery pack components.
• DO NOT attempt to open the battery pack.
• If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
• DO NOT place these batteries in your regular
household trash.
• DO NOT incinerate.
• DO NOT place them where they will become part
of any waste landfill or municipal solid waste
stream.
• Take them to a certified recycling or disposal
centre.
5

OPERATION

5.1

CHARGE PROCEDURE

Before use charge the battery pack fully to make sure
that the battery pack can get the maximum run time.
This battery pack does not have a memory. You can
charge it all the time.
1. Connect the plug of charger (2) to an AC power
outlet.
2. Put the battery pack (1) into the charger (2).
WARNING
NOTE
3
English
This is a diagnostic charger. The Charger LED Light (3)
illuminates in a specified order to show the current
battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO WARM (REMO-
VE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW
BATTERY)
Incorrect Defect Note:
1. Put the battery pack into the charger.
• If the status LED blinks RED, remove the battery
pack from the charger for 1 minute.
2. Put the battery pack into the charger again.
• If the status LED blinks GREEN, the battery
pack is good.
• If the status LED stays blinking RED, remove the
battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LED shows blinks GREEN, the
battery pack is good.
• If the status LED stays blinking RED, the battery
pack is defective and it is necessary to replace
the battery pack.
5.2

EXAMINE THE CHARGER

If the battery pack does not charge correctly:
1. Examine the current of the power outlet with
different machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-
circuited.
3. If the charger is not under usual room temperature,
move the charger and battery pack to a location
where the temperature is between 6 ˚C and 40˚C .
If you put the battery pack into the charger in warm or
hot environment, the charger LED light is red. Pull out
the battery pack and let the battery cool for
approximately 30 minutes.
5.3

MOUNT THE CHARGER

1. Get the location of the wall to attach the charger.
20
GREEN
BLINKING
GREEN
RED
RED
BLINKING
WARNING