Water Filter Status Display; Water Filtration System - Sears Kenmore Elite 10655616400 Manual De Uso Y Cuidado

Your dispenser can be turned off for easy cleaning or to prevent
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product,
to the ice maker, or to the dispenser light. It simply deactivates
the dispenser levers.
To turn off the dispenser, press and hold the lock button until the
red indicator appears below LOCKED. The ice and water
dispensers will not work. To unlock the dispenser, press the lock
button until the indicator disappears. Then continue to dispense
ice or water as usual.
2.
The water filter status display will help you know when it is time
to change your water filter. A new filter should display a reading
of 99%. The number on the display decreases as the filter life is
used. It is recommended that you replace the filter when the 3.
status displays 0% OR when water flow to your water dispenser
or ice maker decreases noticeably. To change the filter, see
"Changing the Water Filter" later in this section.
INDICATOR: STATUS:
99 percent New filter installed
10 percent Order replacement filter
0 percent OR flow decreases Replace filter
After changing the filter, reset the status display by pressing and
holding RESET for 2 seconds. The status display will change to
99% when it is reset.
WATER FILTER
PERCENT REMAINING
• Avoid twisting the cap when removing the filter because
this could cause the cap to come off. If this occurs,
replace the cap and pull the filter straight out.
• There will be water in the filter. Some spilling may occur.
4.
A. Eject button
B. Cap
Remove the cap by turning it counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
Take the new filter out of its packaging and remove the
protective cover from O-rings.
A. Protective cover
B. O-rings
Place the cap (removed in Step 2) on the new filter. Align the
ridge on the cap with the arrow in the filter. Turn the cap
clockwise until it snaps into place.
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
Changing the Water Filter
The water filter is located in the base grille below the freezer
compartment door. It is not necessary to remove the base grille
to remove the filter.
1. Remove the filter by pressing the eject button and pulling
straight out on the cap.
5.
A. Eject button
B. Groove on filter
C. Ridge on cap
Push the new filter into the opening in the base grille. As the
filter is inserted, the eject button will depress. The eject
button will pop back out when the filter is fully engaged.
12