Water Filter - Sears Kenmore PRO 401.40483800 Guía Para El Uso Y Cuidado

HOW TO USE THE WATER
AND ICE DISPENSER
After installation, to flush out
impurities in the water line and to
avoid a plastic smell or taste, throw
away the first six glassfuls of water
and the first full bucket of ice.
Select the Water button for water,
the Cubed button for cubed ice, or
the Crushed button for crushed ice and press a glass
gently against the middle of the dispenser pad. Raise the
glass closer to the chute opening to avoid water splashing
or ice bouncing out of the glass.
NOTE:
The first glass of water dispensed may be warmer than
those following. This is normal.
If no ice appears when one of the ice pads is pressed,
check the dispenser for blockage. Also make sure the
ice chute cover has been removed before use. Also
remember that it takes at least 12 hours after installation
or depletion of the ice supply to make a new batch of ice.
"y!ICAUTION: oo NOT place your hands into
the ice discharge opening. Personal injury could result.
WATER FILTER
This refrigerator has an embedded water
filter. This filter is tested and certified by NSF
against NSF Standard 42 for the reduction
of chlorine taste and odor, and against
Standard 53 for the reduction of pathogens,
insecticides, asbestos, benzol, organic
compounds, and mercury.
When the indicator light on the Filter button turns on
and changes to red, it is time to replace the water filter.
The water filter should be replaced every six months.
Purchase a replacement water filter from a local Sears
store or service center.
To replace the water filter
Open the grille panel at the top of the
refrigerator. Remove the replacement
part of the filter unit by rotating the filter
to the left (counterclockwise) 90 ° to
unlock it, then pull it down. Place a
bucket beneath the filter to catch
dripping water.
Unpack the replacement filter from the
box and peel off the red protective cap.
Place a date sticker on the new filter.
For example, if installing the new filter
in April, put on an "OCT 10" sticker (six
months from the current date).
Place the top of the replacement filter up
into the fixed part of the unit, rotate it to
the right (clockwise) 90 ° , and align the
indicator arrow with the lock icon to lock
the filter.
Close the grille panel on the top of the
refrigerator, place a glass against the
dispenser cradle, and push the Water
button to check for water flow. Run water
for about 2 minutes to clear the system.
Reset the indicator light by pressing the
Filter button for 3 seconds until the light
turns off.