Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AC Power and Power Amplifier Section
40.
AC Power Inlet: This is the receptacle for the supplied
IEC line cord. This provides AC power to the unit.
Connect the supplied line cord to this connector to
provide power to the unit. Damage to the equipment
may result if improper line voltage is used (see line
voltage markings on the unit).
41.
Power: The main power switch for the XR 684F/
XR 696F. The power on LED indicator will light when the
unit is powered.
42.
Fuse: This is the main safety fuse for the AC line voltage. Only replace with a fuse of the exact type and rating. If
the fuse continues to open‚ do not over fuse. Take the unit to an authorized Peavey service center.
43.
Left/Mon Right/Main Speaker Outputs: These
these jacks and to a speaker cabinet‚ you complete the signal chain. You will notice there are two pairs of jacks. The
two pairs are your two (stereo) amplifier outputs. Two cabinets can be connected to each channel as long as the
combined impedance of the cabinets is not less than 4 ohms. (i.e.‚ two 8 ohm cabinets in parallel = 4 ohms‚ four 16
ohm cabinets in parallel = 4 ohms‚ etc.)
43
40
⁄
" jacks are the amplifier's outputs. By connecting a speaker cable to
1
4
14
42
41
43
Tabla de contenido
