Description; Main Applications - Hilti SD 6000 Manual De Instrucciones

Symbols
Return Volts
materials for
recycling
Hertz Alternating
current
Diameter Double
insulated

2 Description

2.1 Use of the product as directed
The SD 6000 is a hand-held, mains-powered electric tool for use in drywall installation.
The SD 5000 is a hand-held, mains-powered electric tool for use in drywall installation.
The SD 2500 is a hand-held, mains-powered electric tool for use in timber construction and drywall installation.
These power tools are designed for driving and removing the recommended screws in materials of the corresponding
type and thickness. Drywall screws with a length of up to 55 mm and a diameter of up to 4.2 mm can be used. Do not
use other types of screws intended for heavy-duty applications.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
For optimum handling, we recommend that the power tool is gripped in line with the motor.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Observe the national health and safety requirements.

2.2 Main applications

Application
Fastening drywall board to
metal framing ≦ 0.88 mm
Fastening drywall board to
metal framing ≦ 2.25 mm
Amps Watts
Rated speed Revolutions
under no per minute
load
Screw type
SD 6000
/ ∅ in mm
x
Drywall screw
with needle point,
type S‑DS 01
x
Drywall screw
with drill point,
type S‑DD 01
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:
SD 5000
x
x
en
SD 2500
13