Operating Instructions - wolfcraft VNC 250 Instrucciones De Uso

Intended use
This vinyl cutter which can be used without any machine is only suitable for cutting self-adhesive or click vinyl
and PVC panels, with a maximum width 45.0 cm and a maximum thickness of 6 mm.
The blade of the vinyl cutter has been made from non-wearing material and comes with a special anti-stick
coating. In order to attain the best cutting results, possible residues of glue should be removed from the blade
or from the aluminium profile. Due to its special shape, the blade needs neither be ground and sharpened nor
is it admissible. The blade holder's screwed connection should be re-tightened, if necessary.
Please note the illustrations on pages 2 - 7 how to assemble and operate the appliance.
Hint: If you want to cut vinyl of a higher thickness, the product can be screwed to a wooden plate, so as to
achieve the largest possible stability.

Operating instructions

1. Raise the cutting blade with the handle upwards
2. Attach the vinyl panel to the guide bar, so that a precise cutting angle of 90 degrees can be ensured.
Hint: Support the other end of the laminate board, so that it will be pushed horizontally against
the guide edge.
3. A clean cut is achieved by pressing the cutting blade with the handle steadily downwards.
Please make sure to push the blade straight down, in order to get an optimal result.
4. Attention: Remove the angle stop before making angular & longitudinal cuts (e.g. for the end boards).
Safety instructions:
• Operate the appliance only by using its handle; keep your fingers off the cutting area.
• Always operate the appliance alone!
• Leave the blade in its closed position, when the appliance is not in use. When opening the blade move it right
to the limit stop at rear.
• Do not make any modifications or changes to the appliance.
• Never sharpen the blade!
• Make sure that both you and the appliance have a safe position on a stable surface.
• Check before starting to work that the equipment used is properly installed (such as screwed connections).
• Make sure your clothing fits tightly (especially the sleeves) and that you wear eye protection.
• Keep children out of your workshop and store your equipment and tools in a secure place.
• Never let inexperienced personnel work with your equipment and tools without duly supervising and
instructing them.
• Always work methodically, in a concentrated fashion and with sufficient lighting.
Guarantee
Dear DIY enthusiast, for this wolfcraft
5 year guarantee.
wolfcraft provides you with a replacement free of charge should damage occur during the guarantee period as
®
a result of material defects. The guarantee period commences on the date of purchase. Please ensure that the
guarantee card is fully completed or keep the invoice in a safe place. A requirement for the validity of this
guarantee is that the purchased appliance is only used around the home, a correct handling and the use of
original wolfcraft ® spare parts. Claims can only be asserted under the guarantee if the guarantee card has
been fully completed.
t
Vinyl cutter VNC 250
product, we give you a
®
9