Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing or removing socket
For tool with light fit detent pin
1
3
2
4
008408
Align the hole in the side of the socket with the detent pin
on the anvil and push it onto the anvil of the tool until it
locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
For tool with firm fit detent pin
1
2
2
4
012052
To install the socket, align the hole in the side of the
socket with the detent pin on the anvil.
Push the socket onto the anvil until it snaps into place.
Tap it lightly if required.
To remove the socket, depress the detent pin through
the hole in the socket and pull the socket off the anvil.
Hook
CAUTION:
After installing the hook, make sure that it is screwed
firmly.
1
3
008150
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1. Socket
2. Hole
3. Anvil
4. Detent pin
3
4
1. Socket
2. Anvil
3. Hole
3
4. Detent pin
4
1. Groove
2. Screw
3. Hook
2
OPERATION
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
008151
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
N m
(ft lbs)
300
(216)
200
(150)
100
(72)
M12(1/2")
0
008488
6
Standrad bolt
M20(3/4")
M16(5/8")
(M16)
(5/8")
1
2
Fastening time(S)
(M20)
(3/4")
(M12)
(1/2")
3
Tabla de contenido
