Foppapedretti BOARDING Manual De Instrucciones página 18

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
• ENGLISH •
ASSEMBLY / USE
ASSEMBLY
HOW TO OPEN THE STROLLER (fig. 1, 2, 3, 4)
Turn the handlebar into position "a", a "click" will indicate that it has been fastened (fig. 1).
Unhook the lever "b", as shown in the figure (fig. 2).
Lift the handlebar until the chassis opens completely. A "click" will indicate that is has been fastened
(fig. 3, 4).
Before using the stroller, make sure it is opened properly and the mechanisms are properly locked.
REAR WHEELS (fig. 5, 6)
Fitting (fig. 5): Insert the pin in the hole on the wheel hub, as shown in figure. A "click" will indicate
that it has been fitted correctly. Repeat on both sides. Check that both the wheels have been fastened
correctly, pulling outwards they should not be released.
Removing (fig. 6): Press button "A" and, at the same time, pull the wheel to remove it from the axis.
BASKET (fig. 7)
The basket is fitted on the lower part of the chassis.
The basket should be emptied before folding the stroller.
CANOPY (fig. 8, 9, 10)
Fitting (fig. 8, 9): Insert the front arch of the canopy into the support: you will hear a "click" when it is
attached correctly. Repeat on both sides.
Insert the rear arch of the canopy into the support: you will hear a "click" when it is attached correctly.
Repeat on both sides.
Removing (fig. 10): With a flat-tipped tool (such as a screwdriver), pry open and slightly lift up tab "a"
on the front canopy support and, at the same time, remove the arch. Repeat on both sides.
With a flat-tipped tool, pry open and slightly lift up tab "b" on the rear canopy support and, at the same
time, remove the arch. Repeat on both sides.
BUMPER BAR (fig. 11, 12)
Fitting (fig. 11): Line the bumper bar up with the slots and press on both sides. A "click" indicates that
it has been fastened correctly.
Removing (fig. 12): Press button "a" on both sides of the bumper bar and, at the same time, pull to
remove it.
USE
PARKING BRAKE (fig. 13)
WARNING: The parking device shall be engaged when placing and removing the children.
WARNING: Never leave child unattended.
WARNING: Never leave the stroller on a slope with the child inside, even with the brakes on.
To apply the brake: Press the brake lever, push the pushchair forward gently to ensure the brake has
been applied correctly.
To release the brake: Lift the lever.
18
Tabla de contenido
loading

Tabla de contenido