Foppapedretti iWood Manual De Instrucciones página 14

INSTALL THE SEAT
(fig.21, fig.22, fig.23, fig.24, fig.25)
Align the seat with the adaptors and press until "click" sound.
Lift up the buttons of the adaptors with one finger at each side and lift up the seat to remove the
seat.
REVERSIBLE SEAT
(fig.26, fig.27, fig.28)
Lift buttons "A" on both sides and remove the seat by lifting it.
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "INSTALL THE SEAT" for correct
assembly.
TO REGULATE THE BACKREST
Lift the regulating lever located behind the backrest and recline the backrest to the required
position. Release the lever and make sure the backrest is secured in position.
SAFETY HARNESS (fig.30)
Apply the brake before placing your baby in the pushchair.
Release the buckle: press button "A" and remove the components
Fasten the buckle: by inserting part a in part b, a click will indicate that it has been fastened
correctly.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance
with the standard BS 6684.
ASSEMBLY / ADJUSTING THE CANOPY
Extend the hood according to requirements to protect baby from the sun.
Note: babies' skin is very delicate. NEVER leave baby under direct sunlight.
Always make sure that the hood has been adjusted correctly.
Remove the rear part of the hood to use it as a parasol.
Open the zip or the viewing window, according to the model purchased, for ventilate.
FOLDING THE PUSHCHAIR
Before folding the pushchair, make sure that:
The seat is forward facing
The backrest is adjusted in the upright position
The canopy is folded
Push the button "A", on the lower side of the right lever and keep pressed while sliding the levers,
left and right, downwards. Fold the stroller. Ensure the locking device "B" is correctly engaged.
Note: It is NOT possible to close the pushchair with the travel system accessories, the infant car
seat and carrycot, fitted on the chassis.
FITTING THE FOOTMUFF
Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair using the press fasteners.
FITTING THE PUSHCHAIR RAINCOVER
Fit the raincover over the hood.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
• ENGLISH •
ASSEMBLY
(fig.29)
(fig.31, fig.32, fig.33, fig. 34)
(fig.35, fig.36, fig.37)
(fig.38)
(fig.38)
14