Set-Up Instructions - NORTH STATES 8666 Manual De Instrucciones

Ocultar thumbs Ver también para 8666:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PROPER SET-UP CONFIGURATIONS
We recommend that you use your
Superyard only as an enclosure,
not as a barrier.
See FIGURE 1 for proper
con guration.
INSTRUCTIONS FOR INSTALLING SKID-RESISTANT PADS
Your North States enclosure can be used on hard surfaces (hardwood oors, tile, linoleum, etc.) by installing
the enclosed skid-resistant pads.
1. Ensure that the surface of the yard panel is clean and dry prior to installing the pads.
2. Remove a single pad from the release paper as shown in FIGURE 2.
3. Place the adhesive side of the pad on the bottom edge of the yard panel approximately 2" from the
center of each hinge, as shown in FIGURE 3.
4. Repeat steps 2 & 3 for each of the remaining pads.
5. Maximum skid-resistance will be maintained by cleaning the bottoms of the pads periodically with
a water-dampened clean cloth.
FIGURE 2

SET-UP INSTRUCTIONS

Begin setting up your enclosure by unsnapping
the gray carrying strap and carefully unfolding the
panels to the proper configuration as shown on
page 2. (NOTE: Models 8765/8768/8777 consist of
eight panels which will form an octagon when set
up properly. Model 8809 consists of four panels
which will form a square.)
When you have finished unfolding the panels,
there will be two unconnected panels arranged as
shown in FIGURE 4. Make certain that the dark
gray carpet foot (D) is up as shown.
Begin connecting the panels together by gently
lifting up on panel 1 and setting the opening "A"
(as shown in FIGURE 5) over pin "B" located on
panel 2.
Now locate the slot on the lower end of cylinder
"D" as shown in FIGURE 6. This slot tapers to an
opening that accommodates pin "C".
Gently press down on panel 1 while aligning pin
"C" with the end of the slot in cylinder "D". While
maintaining downward pressure on panel 1, lift
slightly on panel 2, and slide pin "C" through the
slot and into the opening as shown.
FIGURE 1
INCORRECT
FIGURE 3
CORRECT
CORRECT
INCORRECT
FIGURE 4
PANEL 1
P
FIGURE 5
PANEL 1
PANEL 2
OPENING A
PIN B
CORRECT
D
Dark Gray
Carpet Foot
PANEL 2
C
A
B
FIGURE 6
PANEL 1
PIN C
Page 3
PANEL 2
SLOT IN
CYLINDER D
Tabla de contenido
loading

Este manual también es adecuado para:

866886698728872987648765 ... Mostrar todo

Tabla de contenido