Positioning The Chisel; Setting The Chiseling Power; Types Of Work - Hilti TE 800 Manual De Usario

5.1.4

Positioning the chisel

CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function selector
switch until it engages in the "Chiseling" position.
The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Fit the accessory tool. → page 17
5.1.5

Setting the chiseling power

1. Press the power level selector switch.
➥ The power level indicator lights yellow.
➥ Power is reduced to 70%.
Reduce the power to 70% when you wish to chisel with greater precision.
The chiseling power level can be adjusted only when the tool is plugged in to the electric supply.
2. Press the power level selector switch again to return to full chiseling power.
5.2

Types of work

WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool without
an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always make sure that an earth/ground
conductor and ground fault circuit interrupter are present in the power supply and that these are correctly
connected.
▶ Do not use the product unless these safety measures are in place and fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
5.2.1 Chiseling 5
1. Plug the supply cord into the power outlet.
Working at low temperatures: The hammering mechanism works only when the power tool has
reached a minimum operating temperature. Bring the chisel into contact with the base material
and allow the power tool to run under no load until the minimum operating temperature is reached.
If necessary, repeat this procedure until the hammering mechanism begins to operate.
2. Bring the chisel into contact with the workpiece about 80 -100 mm (3¹⁄₈" - 4") from its edge.
3. To switch the power tool on, push the on/off switch to the right.
➥ The on/off switch remains engaged in this position (on the right).
18 English
Printed: 08.07.2019 | Doc-Nr: PUB / 5200550 / 000 / 05
2064795
*2064795*