Functional Description - Milwaukee 6130-59 Manual De Instrucciones

it is marked with the suffix "W-A" ("W" in Canada)
to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired
and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a
qualified person before using it.
• Protect your extension cords from sharp objects,
excessive heat and damp or wet areas.
Recommended Minimum Wire Gauge
For Extension Cords*
Nameplate Amps
25'
0 - 2.0 18
2.1 - 3.4 18
3.5 - 5.0 18
5.1 - 7.0 18
7.1 - 12.0 16
12.1 - 16.0 14
16.1 - 20.0 12
* Based on limiting the line voltage drop to five volts at 150%
of the rated amperes.
SYMBOLOGY
Double Insulated
Volts
Alternating Current
W
Watts
Rated Revolutions per Minute (RPM)
Seal of Electrical Security
Read operator's manual
Wear hearing protection
Wear eye protection

FUNCTIONAL DESCRIPTION

1
2
7
1. Side handle
2 Spindle lock
3. Slide switch
SPECIFICATIONS
Cat. No. ....................................6130-59, 6130-59A
Volts CA ...................................220-240 V 50/60 Hz
Watts .................................................................750
RPM ..............................................................12,000
Spindle Thread Size .........................................M14
Extension Cord Length
50' 75' 100'
18 18 18
18 18 16
18 16 14
16 14 12
14 12 10
12 10 --
10 -- --
3
4
5
4. Handle
5. Side handle sockets
6
6. Type 27 guard
7. Detent tab
Max Capacity .......... 115 mm (4-1/2") x 6 mm (1/4")
Cat. No. ...................................................6130-59B
Volts CA ..........................................127 V 50/60 Hz
Watts .................................................................750
RPM ..............................................................12,000
Spindle Thread Size .........................................M14
Max Capacity .......... 115 mm (4-1/2") x 6 mm (1/4")
WARNING
removing accessories.
150'
To reduce the risk of injury when grinding, always
16
use properly installed guards.
14
Removing/Installing/Adjusting the Guard
12
12
This tool is shipped with a guard. Always use a guard
--
unless otherwise indicated by these instructions.
--
1. To remove the guard, unplug tool and remove any
--
accessories from spindle.
2. Press in the guard lock lever and rotate the guard
to line up the tabs on the grinder with the slots in
the guard.
3. Press in the lock lever and lift the guard straight
up and away from the tool.
4. To install the guard, unplug the tool and remove
any accessories from the spindle.
NOTE: Use only 4-1/2" grinding wheels with 4-1/2"
guards (available as an accessory). Use only 5"
grinding wheels with 5" guards.
5. Line up the tabs on the grinder with the slots in
the guard.
6. Press in the guard lock lever and press the guard
onto the tool.
7. To adjust the guard, press in the guard lock lever
and rotate the guard to one of five detent slots.
WARNING! Always adjust the guard to provide the
operator with maximum protection while operating.
21
ASSEMBLY
To reduce the risk of injury, always
unplug tool before changing or
Operator's Zones