Cleaning And Maintenance; Miscellaneous - Medisana HKS Instrucciones De Manejo

GB
2 Operating / 3 Miscellaneous
Additional information for the heat pad for neck and back (Art. 60124 HKN)
This specially-shaped back and neck pad is especially designed for use on these
areas of the body. It is individually adjustable to your body thanks to hook and loop
fasteners in the neck and hip areas.

3 Miscellaneous

3.1 Troubleshooting
This unit is equipped with the active protection system APS TECH. The unit detec-
ts different causes of errors and emits corresponding alarm sounds if necessary. In
the case of an error, the power LED will light up in red.
3 beeps in 1-second interval and power LED lights up in red:
The connection cable of the control unit is not properly connected to the heat pad or
another electrical defect is present. Please check the cable connection. Is the cable
connected properly, please do not use the heat pad and contact the service center.
3 beeps in 2-second interval for one minute and power LED lights up in red:
The heat pad is broken, folded or fully covered. Please use the heat pad only
according to this instruction manual and pay attention to all points in the safety
information chapter.
Constant beeping and power LED lights up in red:
Important components are damaged or there is a short circuit. Please do not use
the heat pad and contact the service center.
If there is no function at all after switching on the heat pad (power LED shows
no light and no beeps can be heard), please check if the mains plug is correctly
plugged in the mains outlet. If this is the case, the heat pad is defect. Please do
not use the heat pad and contact the service center.

3.2 Cleaning and maintenance

Heat pad
•
Before cleaning the pad, unplug it from the mains outlet and let it cool down for
at least ten minutes.
•
The heat pad is equipped with a removable control unit
60114 / 60124 / 60144: "HKC, -M, -N"). Unplug the control unit from the heat
pad by pulling out the connection cable from the plug on the heat pad.
•
The heat pad can be cleaned with a soft brush when dry.
•
The heat pad may be carefully washed by hand. Ideally you should place the
heat pad in a bathtub with warm water and a little mild detergent and squeeze
it gently.
•
Rinse the pad several times to get rid of any remaining detergent.
•
Never use strong detergents or hard brushes.
•
To dry, lay the pad flat on a moisture-absorbent towel or mat.
•
Only use the blanket again once it is completely dry.
•
Reconnect the control unit to the heat pad in the
correct manner (please see the sketch, the arrow
markings are showing towards each other).
•
You should untangle the cable from time to time.
•
Store the unit in a clean and dry place, laid out flat
with nothing covering or resting on top of it.
12
G
G
G
G
G
E
(Art. 60104: "HKS"; Art.
E
E
E
E
E
E
E