IMER MASONRY 750 Manual De Uso página 15

the required height from the cutting table and tighten the clamping lever
For safe use of the machine when cutting, push the carriage forwards
as the cut advances, placing your hands to the two sides of the carriage.
Never push directly on the piece to be cut.
against the stop.
2. Start the engine.
3. Wait until the water reaches the blade.
4. Begin cutting.
5. Horizontal cutting movement is carried out by pulling the carriage
towards the blade.
Position the piece to be cut. Start the sawing machine and start cutting
For changing the disk, please refer to paragraph 4.
involves setting the cutter head stroke. This operation is carried out at
the factory by the manufacturer for a 750 mm diameter disk. If not car-
ried out properly, this adjustment can damage the machine and cause
personnel.
Proceed as follows:
1. Make sure that the machine is disconnected from the power supply.
2. Fit the 700 mm diameter disk according to the procedure described
in paragraph 14.
4. Lower the cutting head until the disk is in the best cutting position (the
disk outside diameter should protrude 15 mm from the cutting surface).
5. Turn the cam until locking the cutting head and tighten the bolt.
At this point, the cutting head is adjusted for a 700 mm diameter disk.
changing them when damaged.
Never leave the machine outdoors: it must be sheltered from the wea-
ther.
Below is a list of the cleaning operations that must be carried out at the
end of every shift.
IMER INTERNATIONAL S.p.A.
MASONRY 750
Empty the tank by removing the drain plug. Remove cutting residue
using a jet of water.
Empty the drum opening the drum cap from right or left side.
Always keep work surfaces clean. Residual dirt can impair cutting pre-
cision.
It is good practice to remove all traces of dirt from the guides.
If water does not reach the blade stop the machine immediately to avoid
blade damage.
After stopping the machine check that the water level in the tank is suf-
If necessary, after disconnecting the machine from the power supply
-
1. Switch off the electric motor and remove the plug from the power
supply.
2. Unscrew the 4 screws that secure the movable belt guard (ref.1,
blade support.
Kg to the centre of the free section of the belt, the arrow should be about
alignment of the motor pulley and the blade pulley
1. Switch off the electric motor and disconnect the plug.
disk holder arm.
with the new one.
of the motor pulley and that of the disk.
-
Only use genuine IMER spare parts and do not modify them.
15
GB
-