Tabla de contenido
Angle setup
The angle of this installation bracket can be changed up to 25 degrees. Please be sure to use 2 people when carrying out setup.
1.
Loosen the left and right screws (c) on the vertical frame.
2.
While lowering the arm, press on the display until it is at a suitable angle.
3.
Tighten the left and right screws (c) when the angle is set.
After mounting the unit at an angle, an additional
reinforcement measure can be taken by attaching an
appropriate wire and a flat bar using screws a.
When the angle is set to less than 5°, please secure using
wires or a flat bar etc.
Specification
Weight ............... 7.6 kg (16.8 lbs) (Metal bracket only)
47.9 kg (105.6 lbs) (Metal bracket + Plasma Display <PDP-502MX, PDP-502MXE>)
c
Wire, flat bar
a
When not setting the monitor at an angle from the wall,
tighten the screws on both movable side and fastening side
of the metal hooks as shown above to join the two sides.
This will prevent the frame from opening. (Use screws a.)
Tighten the left and right screws (c) also in this case.
Measuring the opening distance X enables approximate angle
values to be determined.
X
181 mm
236 mm
290 mm
341 mm
X
Angle
5°
10°
15°
20°
<AZR1040>
11
En
Tabla de contenido
