Clatronic WK 2747 Instrucciones De Servicio página 25

4....-05-WK 2747 Beach
1. Place the machine on a flat surface.
2. To open the kettle, use the handle set into the lid
3. Fill it with water. Fill only up to the maximum mark (MAX). You can check the
level on both sides of the appliance with the water level display.
4. Close the lid.
5. Place the kettle flush on the base.
6. Electrical connection
• Check whether the electrical voltage that you intend to use is the same as
that of the machine. Details are to be found on the label on the base.
• Only connect the machine to a properly installed 230 V, 50 Hz safety socket.
7. Switch on the appliance with the switch on the handle.
8. The control lamp in the on/off switch lights up.
9. After boiling the machine switches off automatically. Disconnect the machine
from the mains electricity supply. Keep the lid closed when pouring. Danger of
burning!
• Always pull out the plug from the socket before cleaning!
• The exterior of the machine should be cleaned, if necessary, with a slightly
damp cloth without additives.
• To clean the kettle, remove the lime filter by pulling it upwards by the upper lip.
Remove the lime deposits by rinsing the filter under running water.
The frequency of the decalcifying operation depends on the hardness of the water
and on how often the appliance is used. Decalcify the appliance every 3 to 4
months. If the machine switches off before the water boils, it probably needs to be
decalcified. Please do not use vinegar but a commercially available decalcification
agent on the basis of citric acid. Only use the quantities stated in the instructions.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
16.09.2002 8:48 Uhr
Operation
Cleaning
Decalcification
Seite 25
GB
25