Extension Cords; Functional Description - Delta TS350 Manual De Instrucciones

EXTENSION CORDS

Use proper extension cords. Make sure
your extension cord is in good condition and is a 3-
wire extension cord which has a 3-prong grounding
type plug and matching receptacle which will accept
the machine's plug. When using an extension cord, be
sure to use one heavy enough to carry the current of the
machine. An undersized cord will cause a drop in line
voltage, resulting in loss of power and overheating. Fig.
D-1 shows the correct gauge to use depending on the
cord length. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
FOREWORD
The Delta TS350 is a 10" Table Saw designed to give high quality performance with depth-of-cut capacity up to 2-
7/16" (62mm) at 90° for clean cutting of standard stock sizes. This tool includes the basic machine, a sturdy steel
stand, a T-Square fence system, a T-Slot miter gauge, a 10 amp motor, a cast-iron table with extension wings (22-1/4"
x 38-1/2"), a see-thru blade guard with anti-kickback fingers, convenient up-front blade adjusting controls, and a 10"
carbide blade.
NOTICE: The manual cover illustrates the current production model. All other illustrations contained in the manual are
representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.

FUNCTIONAL DESCRIPTION

6 - English
MINIMUM GAUGE EXTENSION CORD
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Total
Length of
Ampere
Cord in
Rating Volts Feet
0-6 120 up to 25
0-6 120 25-50
0-6 120 50-100
0-6 120 100-150
6-10 120 up to 25
6-10 120 25-50
6-10 120 50-100
6-10 120 100-150
10-12 120 up to 25
10-12 120 25-50
10-12 120 50-100
10-12 120 100-150
12-16 120 up to 25
12-16 120 25-50
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
Fig. D-1
Gauge of Extension
Cord
18 AWG
16 AWG
16 AWG
14 AWG
18 AWG
16 AWG
14 AWG
12 AWG
16 AWG
16 AWG
14 AWG
12 AWG
14 AWG
12 AWG