Operating Instructions - Gaymar TP472 T/PUMP Manual Del Operador

OPERATING INSTRUCTIONS

4.0 Operating Instructions—Start-up
Use the TP472 T/Pump only with Gaymar
T/Pads or Mul•T•Pads. Contact your dealer for
a list of available Gaymar pads.
1. Before filling, always attach a T/Pad to the connector
hose on the T/Pump or connect ends of the T/Pump
hose together (see fig. 2). Unkink pad and hose.
Open hose clamps.
2. Fill the pump with room temperature (i.e., not hot)
distilled water to the operating level indicated on
the side of the pump:
Recommended operating level
(water)
NOTE: Using tap water will decrease the life
of the pump.
3. Insert temperature setting key. Set temperature as
prescribed by the physician. Remove key to prevent
tampering.
4. Plug T/Pump into a properly grounded outlet.
5. Turn on the power switch. The selected water tem-
perature will be reached in approximately
20 minutes.
6. If the water level drops below the operating level,
add water. Do not overfill. Overfilling can result
in reduced pump motor life.
7. Apply T/Pad to the patient. Follow T/Pad instructions.
8. For specified performance, keep the pump at or
above the level of the pad.
9. If the pump is placed below the pad(s), water will
drain into the pump when it is shut off. If the pump
has been overfilled or if multiple pads are connected,
excess water can leak out onto the floor or fill the
reservoir and cause reduced motor life.
4.1 Operating Instructions—Shutdown
6
A
C
Figure 2—Clik-Tite
1. Turn off pump before disconnecting pad. Close
hose clamps.
To prevent water spillage, always disconnect pad
from pump with connectors raised above the level of
the pad and pump.
2. Connect the T/Pad Clik-Tite connectors together.
3. Connect the ends of the connector hose together.
TP472 T/PUMP
B
D
Connectors
®