Pentair Intellibrite 5G Guia De Instalacion página 12

INSTALLING THE INTELLIBRITE COLOR POOL AND SPA LIGHT
FIXTURE (AFTER ELECTRICAL REqUIREMENTS ARE MET)
ite White LED light (after electrical requirements are met)
To install the IntelliBrite light fixture:
1. Feed cord through conduit to Junction Box, leaving at least 1.2 meter of cord
at the light fixture to coil around the light (this allows the light to be serviced
after the pool is filled with water). See Figure 1.
To GFCI Circuit
Breaker and
Power Source.
Rigid
Conduit
Figure 1.
2. Cut the cord at the Junction Box, leaving at least 15cm of cord to make
connections.
3. Strip back 15cm of the outer cord jacket to expose the three insulated wires
(be careful not to damage the insulation on the two (2) inner wires).
4. Connect all three (3) wires to the corresponding circuit wires in the Junction
Box and secure the Junction Box cover in place.
5. Install the IntelliBrite light assembly into the niche and tighten the special bronze
pilot screw.
ten (10) seconds unless it is totally submerged in water. Without total
submersion, the light assembly will get extremely hot, which may result in
serious burns or in breakage of the lens. This may result in serious injury
to pool users, installers, bystanders or damage to property.
120cm
min.
10cm min.
Ground Connector
bonding is
located at rear
of niche.
Never operate this underwater light for more than
20cm min. Junction box or Low
Voltage Transformer, to the max.
water level of the pool.
45cm min. to top of Lens.
Concrete must be cut
back around niche to
allow for a compacted
plaster seal.
Coil 1m of light
cable around the
fixture.
40cm
12
11.50" (29.20cm)